| Package # | SC-MIN-14-389 | QBE Nomination Closing Date | February 11, 2014 | ||
| Title | MARINE NAVIGATIONAL AID INSPECTION SERVICE | Tender Issue Date | TBA | ||
| Bid Closing Date | TBA | ||||
|
|||||
Contract Scope
3.1. Detailed Scope of Work to be performed by the Contractor shall include the following:
The Contractor shall provide certified technician(s) to perform as a "Turn Key Service" the Work as described below:
3.2. Annual Inspection of the DGPS in Edwards Cove to confirm the signal integrity. This shall be completed through the measurement of two (2) established reference points. These points shall be at mid range, approximately Mt. Pickle, and far field, approximately Skull or Humbey’s Island. These measurements combined with the integral monitoring of the DGPS will assure operational stability.
Servicing is composed of equipment tests, antenna mount integrity on the tower and inspection of the insulators mounted along the length of the tower.
3.3. Annual inspection of the towers and lights, as listed below in Section 3 from Edwards Cove out to Turtle Island.
(a) All light sources to be maintained within Canadian Coast Guard rated intensities.
(b) During the annual inspection the batteries, charging systems, lights and all VHF radios shall be checked for range, stability and accuracy.
(c) As part of Fixed light routine maintenance the lights will be replaced during 2017, thus maintaining the Canadian Coast Guard rated intensity levels.
(d) Integrity checks of the alignment of Range lights and Sector lights shall be completed by conducted using a boat with certified design engineers as required by the Canadian Coast Guard.
(e) As part of the Sector Light routine maintenance, this unit will require a major overhaul at the end of five (5) years of operation. The cost of this is covered in the "Turn-key" rate.
(f) The day markers will be replaced or repaired as required during routine maintenance. The cost of this is covered in the "Turn-key" Rate.
(g) All towers shall be tested and re-torqued to specifications throughout to ensure consistency along with tests of all anchor locks, guy wire tension, and tower safety rails and platforms
(h) This Annual Inspection shall be completed in conjunction with the Annual inspection of the DGPS as per Item 2.1.
3.4. Annual Inspection of the floating buoys to confirm physical condition of buoys, positioning and lighting.
(a) Should the buoy have moved it shall be relocated to the correct position.
(b) The Contractor shall maintain the operational integrity of the light by completing position tests, maintaining light in operational condition excluding ice breakup season when the light is removed by the Contractor for prevention of damage.
(c) The Contractor shall replace the light each season shortly after the ice is gone.
This service will be completed utilizing a chartered boat from Nain equipped with GPS. Should the buoy require relocation an appropriately sized boat will be used.
(d) Replacement of the light is the responsibility of the Contractor.
(e) The routine maintenance of this unit requires the private nav-aid identifier "PRIV" to be replaced annually due to ice damage.
(f) Chain is rated for Ten (10) years before an inspection is required. Contractor will request the Canadian Coast Guard to conduct one inspection during the Term of this Agreement.
3.5. As recommended by the Canadian Coast Guard the Range lights at Uigortlik Island shall be converted to VHF control. The system shall be modified to operate in this fashion. The Contractor shall supply and install all required equipment including additional expanded solar panels.
3.6. Preparation and submission of specific reports with respect to Items 2.1, 2.2, &2.3 to the designated Company Representative including:
(a) Condition Report;
(b) Failure Analysis;
(c) Cost estimates and timelines for any required maintenance; and
(d) Documentation verifying that all work has been completed, inspected, and approved in accordance with Canadian Coast Guard Regulations.
4. LIST OF NAVIGATIONAL AIDS
Voisey’s Bay Channel – FIXED LIGHT
Approximate Position: 56˚26.3’N 61˚57.44’W
Tower 3.65 m
Daymark Green over White on three sides
Light Colour Green
Nominal Range 4 nm
Flash Characteristics 4s
Light Type API-FA-249-LED C/W 1 EA 40W SOLAR PANEL AND FIVE BATTERIES
North West End of Kikkertavak Island - FIXED LIGHT
Approximate Position: 56˚24.95’N 61˚45.7’W
Tower 3.65 m
Daymark Green over White on three sides
Light Colour Green
Nominal Range 4 nm
Flash Characteristics 4s
Light Type API-FA-249-LED C/W 1 EA 40W SOLAR PANEL AND FIVE BATTERIES
Sentinel Hill - FIXED LIGHT
Approximate Position: 56˚25.28’N 61˚32.65’W
Tower 4.9 m
Daymark Red over White on three sides
Light Colour Red
Nominal Range 4 nm
Flash Characteristics 4s
Light Type API-FA-249-LED C/W 1 EA 40W SOLAR PANEL AND FIVE BATTERIES
False Start Island – FIXED LIGHT
Approximate Position: 56˚27.18’N 61˚05.87’W
Tower 3.65 m
Daymark Green over White on three sides
Light Colour Green
Nominal Range 4 nm
Flash Characteristics 4s
Light Type API-FA-249-LED C/W 1 EA 40W SOLAR PANEL AND FIVE BATTERIES
Dugong Islet – FIXED LIGHT
Approximate Position: 56˚30.23’N 61˚08.75’W
Tower 3.65 m
Daymark Red over White on three sides
Light Colour Red
Nominal Range 4 nm
Flash Characteristics 4s
Light Type API-FA-249-LED C/W 40W SOLAR PANEL AND FIVE BATTERIES
Turtle Island – FIXED LIGHT
Approximate Position: 56˚30.14’N 61˚07.04’W
Tower 4.87 m
Daymark Green over White on three sides
Light Colour Green
Nominal Range 4 nm+
Flash Characteristics 4s
Light Type API-FA-249-LED C/W 1 EA 40W SOLAR PANEL AND FIVE BATTERIES
North East End of Uigortlek Island – RANGE LIGHT – REAR (List of Light # 324.674)
Approximate Position: 56˚24.52’N 61˚16.14’W
Range Towers 6.04 m
Daymark Trapezoid 4000x6000x2000 White/Red/ White
Light Colour Green
Nominal Range 6 nm + GPS Synchronized
Light Type Tideland RL200: API-FA-240-LED C/W 120/150W SOLAR PANEL C/W BATTERY BANK AND RADIO CONTROLLED ACTIVATION
North East End of Uigortlek Island – RANGE LIGHT-FRONT (List of Light # 324.673)
Approximate Position: 56˚24.52.4’N 61˚16.14.7’W
Range Towers 15.24 m
Daymark Trapezoid 4000x6000x2000 White/Red/ White
Light Colour Green
Nominal Range 6 nm + GPS Synchronized
Light Type Tideland RL200: API-FA-240-LED C/W 120/150W SOLAR PANEL C/W BATTERY BANK AND RADIO CONTROLLED ACTIVATION
Unknown Island – RANGE LIGHT-REAR (List of Lights # 324.671)
Approximate Position: 56˚22.16.4’N 61˚09.21.7’W
Range Towers 12.19 m
Daymark Trapezoid 4000x6000x2000 White/Red/ White
Light Colour Green
Nominal Range 6 nm+ GPS Synchronized
Light Type Tideland RL200: API-FA-240-LED C/W 120/150W SOLAR PANEL C/W BATTERY BANK AND RADIO CONTROLLED ACTIVATION
Unknown Island – RANGE LIGHT-FRONT (List of Lights # 324.670)
Approximate Position: 56˚22.16.4’N 61˚09.21.7’W
Range Towers 6.10 m
Daymark Trapezoid 4000x6000x2000 White/Red/ White
Light Colour Green
Nominal Range 6 nm+ GPS Synchronized
Light Type Tideland RL200: API-FA-240-LED C/W 120/150W SOLAR PANEL C/W BATTERY BANK AND RADIO CONTROLLED ACTIVATION
Mount Pickle – SECTOR LIGHT (List of Lights # 324.672)
Approximate Position: 56˚23.12.4’N 61˚11.34.8’W
Tower 3.65 m
Daymark Rectangular 2100x1200 White/Red/ White (Vertical)
Sector Light Colour Green/White/Red
Nominal Range 6 nm+
Line of Bearing Approximately 324 degrees true
Light Type Tideland RL200: 100 Watt Halogen Source through segmented lens C/W 1 EA 40W SOLAR PANEL AND FIVE BATTERIES
5. FLOATING BUOY - OUTSIDE SCOPE
5.1. The buoy was placed by CCG and the Contractor paid CCG for this as part of our contract. The structural inspection of the buoy is limited to visual which means the position, markers and light damage. This damage to markers and light is extensive and requires complete replacement every year. As for the integrity of the chain holding the buoy in place the chain is rated for approximately ten years before an inspection is due, however since the CCG do maintain other facilities in the area the Contractor will request that it be inspected once during the term of this new contract.
5.2. A failure of the anchor chain or a failure of the buoy structure itself will be considered outside the scope of work.
5.3. Any costs for replacement or positioning as a result of chain failure shall be for the Company’s account.
5.4. At the sole discretion of the Company, the Contractor may be assigned the Work.
6. TOWER - OUTSIDE SCOPE
6.1. The wind rating of the towers is per the specifications provided by the Canadian Coast Guard and the Company and the towers meet those specification.
6.2. Should the tower(s) be exposed to extreme weather exceeding climate norms where a catastrophic tower failure occur replacement and repair will be considered outside the scope.
6.3. Following mutual agreement that the failure was a result of "weather exceeding climate norms" any costs for replacement shall be for the Company account.
6.4. At the sole discretion of the Company, the Contractor may be assigned the Work.
7. SPARE INVENTORY
7.1. Spares are maintained by the Company at the mine site. This inventory is replaced when consumed as part of the "Turn-key" rate at no cost to the Company.
7.2. Spare Inventory Listing as follows:
1 RL200LED Retro insert, green (forRL200 range lanterns) 751.1073-04
1 Three degree spreader lens, clear (RL200 range lanterns) 302.1061-10
1 L/A Battery, VIVA V12MF (for external solar power system) 182.1078-00
1 SolaLED-140W-4+2 lantern (green) FL4S (09) 010.1154-14
1 SolaLED-140W-4+2 lantern (red) FL4S (09) 010.1154-11
1 LED comm programming kit 901.1199-00
1 Ten watt solar panel 045.1067-00
8. COMPANY FURNISHED SERVICES AND FACILITIES
8.1. As per the General Contract Appendix B Section 3 when and if required.
9. SAFETY EXECUTION PLAN
9.1. Contractor shall be responsible for its Safety Execution Plan, including but not limited to its Safety Policies, Plans, Procedures and Certifications as part of the requirements set forth in the Contract Documents.
3.1.2. same
4. COMPANY FURNISHED SERVICES & FACILITIES
4.1. The Company will provide the Contractor, at no cost, specifically for the performance of the Work of this Contract, the following Services and Facilities:
4.1.1. List items …
4.1.2. List items
5. COMPANY FURNISHED EQUIPMENT & TOOLS
5.1. The Company will provide the Contractor, at no cost, specifically for the performance of the Work of this Contract, the following Equipment and Tools:
5.1.1. List Items …
5.1.2. List Items
6. COMPANY FURNISHED CONSUMABLES & MATERIALS
6.1. The Company will provide the Contractor, at no cost, specifically for the performance of the Work of this Contract, the following Equipment and Tools:
6.1.1. List Items …
6.1.2. List Items
7. OTHER
7.1. [Enter: Additional Scope related articles or delete]